Orange Windows - get it?  A little like the Orange Peel block and a little like a faux Cathedral Windows block?  I'm so funny!

 We are starting the second half of the Skill Builder Sampler!  This month it is all about applique.  Applique is the process of sewing a small piece of fabric onto a larger piece.  We could spend a whole year on applique but we will touch on the basics and then you can continue to practice and improve your technique.

This block is made with raw edge applique - that is the edges of the fabric are not turned under when they are sewn onto the background fabric.  My husband insists that raw edge applique is cheating, but it is a simple, fast and effective method and even he said the finished block was "really nice - one of my favorites."  :)

When I first heard about raw edge applique I was worried that there would be a lot of fraying.   But if the pieces are attached with a product like Heat n Bond the fibers of the fabric are almost glued together and the chances of fraying are almost zero.


To make this block you will need:

• A Compass
• Card stock
• Heat n Bond
• 12.5 inch square of background fabric
• Fabric Scraps

First, make a template for the petals.
Cut a 3 inch square piece of card stock.  I just used my rotary cutter and ruler.
Next, place the point of the compass in the corner of the card stock and open it until the pencil touches the adjoining corner.  Draw an arc from corner to corner.

 Place the point of the compass on the opposite corner and draw another arc from corner to corner.  Cut out the template.

 Next get out your Heat n Bond.  Heat n Bond has paper on one side and sticky on the other.

 Trace the petal shape on the paper side of the Heat n Bond 16 times.

 Rough cut around each petal and iron onto the back of your petal fabric following the directions on the package.

 Cut out all the petals just inside the line drawn on the paper.

 Cut the background fabric into a 12.5 inch square.

 Fold in half along the diagonal and iron.

 Fold in half again and iron.

 There should be visible folds from corner to corner.  These will serve as a guide for positioning the petals.

 First, lay out the petals and decide on an arrangement that suits you.  It might help to take a picture to refer to .

 Remove the petals.  Find the center of the fabric and place a petal with one point at the center and the other point along the diagonal line.  Press just the center to keep it in place.  (If you need to adjust a petal you can pull it off and reattach it - they will lose some of their adhesion and leave a bit of a residue - but if you are putting another petal in the same place it shouldn't be a big deal.  But I definitely wouldn't make a habit of it.)

 The corner petals point should be a quarter of an inch from the sides of the background fabric.

 Attach the petals along the second diagonal.

 Then add the side petals.  Their lower points should touch the points of the petals on the diagonals and their top points should touch each other 1/4 inch from the edge of the background fabric.

 Repeat for all four sides.  When you have all of the petals tacked down, give them a good iron - make sure all of the points are good and stuck.

 Now it is time to stitch around the edges.  But before we get started, change your thread to a color that blends well with most of your petals - unless you want the contrast.  You can use a zig zag or button hole stitch to finish the edge.  I used a zig zag.  Play around with the stitch length and width on a scrap piece of fabric until you are satisfied.  I wanted my zigs and zags fairly wide and close together and set my stitch length to .5 and width to 3.5.

If you haven't stitched along the edge of anything before, take a scrap of fabric,  place it on top of another scrap and stitch along the edge of it.  One side of the zig should go barely off of the scrap petal and onto the background fabric.  Play around until you have the hang of it.

Start sewing around the petals at one corner of the block.  Don't worry about back stitching, because we will end at the same spot and back stitch then.  Start stitching along the top edge of the petal.

 When your reach the point, continue on stitching the under side of the next petal in line.  When you reach it's point (the center of the block) continue stitching on the upper side of the 3rd petal in line and so on.

 When you reach the corner, stop with the needle down and turn around.  Stitch along the opposite sides of the petals until you reach the starting point.   Back stitch just a few stitches.  Repeat for the petals on the other diagonal.

Now stitch down the petals around the edges.  There is a simple way to sew down the rest of the petals without having stop once.  Just follow the arrows in my high tech diagram.  ;)  Start sewing at the star and follow the black arrows all the way around the block going over and under the petals.  When you reach the edges of the fabric you will need to stop with the needle down and rotate in place a bit to start on the next petal.  When you reach the beginning star, stop with the needle down, rotate and start stitching on the underside of the first petal.  Follow the white arrows around the block.  Back stitch a few stitches when you reach the beginning again.

 And you did it!  I really enjoyed making this block.  Wouldn't it be fun to make a bunch and join them together into a large quilt?